Home / Life style cannabis / Zenpype Buzz / 4 Things To Add On Your Bowl Or Joint For That Extra Kick

4 Things To Add On Your Bowl Or Joint For That Extra Kick

Looking to spice up a bit your ordinary joint or bowl? If so, then try adding a little something extra to your weed, specifically concentrated cannabis. Not only will it enhance the flavor of your smoke, but it can also improve the overall appearance. Although certain additives are difficult to mix in, some are rather simple to add.

Put kief on the end of a joint or blunt

First, to add kief on the end of your joint, you need to apply shatter. Again, you’ll need to hold a lighter to your shatter so that it becomes sticky. After it becomes nice and goopy, just roll the end of your joint into the kief.

Roll concentrates and kief inside of a joint

In fact, concentrates and kief can go both inside and outside of a joint. By adding the two, it makes the joint burn more slowly. Also, it makes it far more potent than your standard joint. However, adding too much kief will cause a joint to burn improperly. So, be sure to only scatter just a tad over your flower.

As for concentrates, it’s crucial that you place them in the center and fold the weed over as you roll. Otherwise, they will stick to the paper and will not burn. Then you’d be left with runs in your joint, which ruins it all. Make sure you add your flower before your concentrates, and you’ll be solid.

Twax the tip of a joint or blunt

Twaxing the end of your joint makes for one beautiful masterpiece. By drizzling some shatter onto the tip, it’ll give your joint the extra kick that it needs. Whether you’re using crumble or shatter, make sure you add flame to it using a lighter so that it will boil and melt rather than burn all at one time. As a result, you’ll be left with gorgeous shatter webs.

Apply shatter on the outside of a joint or your blunt

Ever wondered how people make those spiral, golden delights on the outside of their joints? If so, you’re about to find out.

To start with, you’ll need to grab your shatter and warm it up with your fingers. Once it loses its stability and stretches out to the length you desire, then you can begin wrapping it around the outside of your joint.

In case you’re dealing with stubborn shatter that doesn’t want to lose its stability, then just place it onto a dabbing rig and apply heat using a lighter. You can try out this method when adding shatter to the tip of a joint as well.

  • Do you have any other ideas?

  • 148


Your opinion matters!

Notify of